Installing front wheel housing trim: VW Polo 6R
Step-by-step installing front wheel housing trim for the VW Polo 6R: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten bolt (2) to specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Preparing body component for bonding .
- Installation instructions
- Apply 1-component glass adhesiveDH 009 100 A2 to bonding area (6), using cartridge gunV.A.G 1628.
- Insert front wheel housing trim (1) into side member extension and press onto wing.
- Pull protective foil (3) off front wheel housing trim (1) and press on in one direction.
- Tighten bolt (2) to specified torque of 2 Nm. — 2 Nm (1.5 lb-ft)
- Pull out pullers (4) and press front wheel housing trim (1) on.
- Minimum curing period
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing AC/DC converter with socket, 12 V - 230 VU13
- Filling, bleeding fuel system – VW Touareg II
- Checking for injectors sticking open – VW 2.0 TDI
- Removing and installing exhaust gas temperature sender 3G495
- Removing undamaged rear side window – VW
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.