Installing and adjusting multifunction switch F125: VW Sharan I / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan I / SEAT Alhambra (7M)

📋 Procedure

1. Place multi-function switch F125 on selector shaft.
2. Tighten securing bolts (arrows) for multi-function switch F125 until finger-tight.
3. Place setting gauge on selector shaft and secure it.
4. Move selector shaft lever on gearbox to position "“N”".
5. Turn switch so that dowel hole in switch housing (1) lines up with hole in setting gauge.

6. Push in dowel pin (2) of setting gauge.
7. Tighten securing bolts (arrows) for multi-function switch F125.
8. Push on connector (2) of wire for multi-function switch.
9. Push lever (1) onto selector shaft.
10. Tighten nut (arrow).
11. Install selector lever cable .
12. Install battery and battery holder Electrical system27Battery; Removing and installing battery.
13. Bolt on coolant expansion tank.
14. Push connector onto coolant expansion tank.
15. Install trim (2) for battery.
16. Install trim (1) for air duct (arrows).
17. Reconnect earth strap to battery.
18. Code radio Radio, telephone, navigation91Radio systems.
19. Initialise electric windows and set clock 10.1Sharan 1996 ▸.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Repairing bearing plate
• Checking electronic power control (EPC)
• Exhaust manifold, front exhaust pipe and catalytic converter with attachments
• Dismantling and assembling heater and air conditioner unit
• II - Assembly overview - wheel bearing