Adjusting multifunction switch F125 — VW
Adjusting multifunction switch F125 on VW: 7 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 602, 612, 641, 642, 643, 604, 644, 614, 603
Don't miss
- Do not kink selector lever cable.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Tighten bolts (arrows) |
| 6 Nm (4.4 lb-ft) | Tighten bolts (arrows B) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Move selector lever to position "“N”".
- Do not kink selector lever cable.
- Place setting gauge on selector shaft (2) and turn multifunction switch (1) until setting gauge engages in lug on multifunction switch connector.
- Secure setting gauge on selector shaft (2) with bolt (3).
- Tighten bolts (arrows) to 6 Nm. — 6 Nm (4.4 lb-ft)
- Remove setting gauge.
- Continue installation in reverse order of removal .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing exterior mirror · 2 torque figures
- Renewing needle bearing (polygon bearing) and oil seal for right flange shaft
- Removing and installing front seat belt (4-door models) – VW · 2 torque figures
- Removing and installing particulate filter (LHD) – VW CFWA
- Removing and installing seat trim on sill side, seat with height adjustment · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.