Front seat belt (Saveiro "“double cab”") - remove and install — VW
Front seat belt (Saveiro "“double cab”") - remove and install on VW: 15 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 5U4, 5U3, 5UA, 5UC, 5UB
- Renewed: self-locking nuts
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | ⚠ Replace self-locking nuts and bolts subject to angular torque — Tighten the securing… |
| 40 Nm (30 lb-ft) | Tighten the securing bolt (1) to the torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tilt the belt guide cover (2).
- Remove the securing bolt (1).
- Remove the director (3).
- Remove the side lining .
- Remove the lower fastening point of seat belt(6).
- Remove the seat belt clip (4).
- Disconnect the connector (9).
- Remove the securing bolt (10).
- Remove the retractor (11) of B-pillar.
- ⚠ Replace self-locking nuts and bolts subject to angular torque — Tighten the securing bolt (10) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
- Install the seat belt clip (4).
- Install the belt guide (3).
- Tighten the securing bolt (1) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
- Remove the lower fastening point of seat belt (6).
- Install the side lining .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing coolant pipe for low-temperature cooling circuit
- Removing and installing high-pressure pipe – VW Touareg II
- Removing and installing right engine support – VW Touareg II
- Removing and installing catalytic converter on right – VW CKDA
- Removing and installing information electronics control unit 1
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.