Rear seat belt lower fastening point (Saveiro "“double cab”" ) - remove and install — VW

🧭 Before you start

Fits: platform codes 5U4, 5U3, 5UA, 5UC, 5UB

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove rear seat .
2. Remove the securing bolt (2).
3. Remove the lower fastening point of the rear seat belt (1).
4. Install the lower fastening point of the rear seat belt (1).
5. Tighten the securing bolt (2) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
6. Install the seat bottom of the rear seat.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Dismantling and assembling drive shaft, constant velocity joint VL107
• Removing and installing engine control unit J623 with protective housing (Polo)
• Removing and installing engine bracket, Passat, Eos and CC
• Renewing wiper motor
• Draining and filling gearbox oil – VW 2.0