Front seat belt lower fastening point (Saveiro "“single cab”" ) - remove and install — VW

🧭 Before you start

Fits: platform codes 5U4, 5U3, 5UA, 5UC, 5UB

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the cover (1).
2. Remove the securing bolt (2).
3. Remove the lower fastening point of seat belt (3).
4. Install the lower fastening point of seat belt (3).
5. Tighten the securing bolt (2) with (40 Nm) of torque, and install the cover (1). — 40 Nm (30 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing supercharger input shaft seal – VW 1.4 · 1 torque figures
• Removing and installing lower front coolant pipe – VW
• Removing and installing wing – VW Touran II · 1 torque figures
• Removing and installing trim · 1 torque figures
• Removing and installing steering rack, left-hand drive vehicle (3rd generation) from model year 2009