E - Check rotor installation position on the crankshaft — VW

🧭 Before you start

Fits: platform codes 5W9, 5W1, 5W5

• Special tools named: feeler gauge

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Turn hexagonal nut (A) until it reaches the end of the threaded hole.
2. Remove both M6×35 mm screws (B) from the cylinder block.
3. Remove the three screws (C) from the flange.
4. Release the Fitter.
5. Remove the seal lip support ring.

6. Place the calliper or ruler against the crankshaft flange (A) (marked surface).
7. Using feeler gauge (A) , measure the distance (a) between the calliper or ruler and the rotor.
8. Press the rotor again .
9. Release the Fitter.
10. Turn the flange fastening screws, alternating between them in a cross pattern. Tightening torque: 10 Nm. — 10 Nm (7.4 lb-ft)
11. Install the Engine speed sensor G28(arrow). Tightening torque: 5 Nm. — 5 Nm (3.7 lb-ft)
12. Install the oil pan .
13. Install intermediate plate.
14. Install flywheel using new screws.

Other VW procedures

• Camshaft - repair
• Piston and connecting rod - remove and install
• Cylinder head - assembly and disassembly
• Crankshaft - remove and install
• Cylinder head - disassemble and assemble
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures