E - Assembly position of the rotor on the crankshaft - check — VW

🧭 Before you start

Fits: platform codes 5X1, 5W1

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Thread the hex nut (A) until it reaches the end of the threaded spindle.
2. Remove both M 6 × 35 mm screws (B) from the engine block.
3. Remove the three screws (C) from the flange.
4. Remove the device to be assembled.
5. Remove the seal lip support ring.

6. Place the Depth calliper - 1/20 - 300 mmVAS 6082 over the crankshaft flange.
7. Measure the distance (a) between the crankshaft flange and the Engine speed sensor G28 rotor.
8. Press the rotor again .
9. Remove the device to be assembled.
10. Turn the flange fastening screws, alternating between them in a cross pattern. Tightening torque: 10 Nm. — 10 Nm (7.4 lb-ft)
11. Install the engine speed sensor (arrow). Tightening torque: 5 Nm. — 5 Nm (3.7 lb-ft)
12. Install the oil pan .
13. Install intermediate plate.
14. Install flywheel using new screws.

Other VW procedures

• Lubricating system components - assembly overview
• Crankshaft - remove and install
• Intake manifold, front exhaust pipe with catalytic converter and accessories.
• Tensioning element without adjustment · 10 torque figures
• VW recommendations gearbox removal & installation · 3 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures