Dismantling and assembling "K1" clutch housing: VW Golf IV / Bora

🧭 Before you start

Fits: VW Golf IV / Bora (1J)

📋 Procedure

1. Remove retaining ring for plates.
2. Remove plates.
3. Slowly and carefully press down piston cap only far enough that the ring can be removed.
4. Remove retaining ring.
5. Remove piston cap and spring.

6. Drive piston out of clutch housing.
7. To do this, gently strike a plastic mallet against the upper edge of the clutch housing.
8. Carefully press piston by hand into clutch housing to stop.
9. Lay spring, piston cap and retaining ring in clutch housing.
10. Carefully centre piston cap before pressing it down.
11. Slowly and carefully press down piston cap only far enough that the ring can be installed.
12. Install retaining ring.
13. Install plates.
14. Install retaining ring for plates.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking engine operating statuses – VW Passat B5 2.3 AZX
• Checking secondary air system – VW Passat B5
• Removing and installing starter, 2.0 l, 103 kW TDI engine, dual clutch gearbox (DSG) DQ250-6F
• Removing and installing wiper arm
• Removing and installing spray jet assembly – VW Golf Cabriolet