Gearbox removal & installation: Connecting vehicle diagnostic, testing and information systemVAS 5051A — VW

🧭 Before you start

Fits: platform codes 6E1, 6X1

Don't miss

• All other and the following vehicle diagnostic, testing and information systems or vehicle diagnostic and service information systems are connected accordingly in the sequence described above.

📋 Procedure

1. Apply handbrake.
2. Vehicles with an automatic gearbox, move selector lever to position "“P”" or "“N”".
3. In vehicles with Direct-Shift Gearbox, move selector lever to position "“N”" or "“STOP”".
4. Vehicles with manual gearbox, move selector lever to neutral position.
5. Lever cover out of centre console.

6. With ignition switched off, connect vehicle diagnostic, testing and information systemVAS 5051A using diagnostic cableVAS 5051/6A to diagnostic interface (arrow) in vehicle.
7. Pull ashtray insert out of centre console.
8. With ignition switched off, connect vehicle diagnostic, testing and information systemVAS 5051A using diagnosis cableVAS 5051/6A to diagnostic interface (arrow) in vehicle.
9. Switch on ignition.
10. Switch off all electrical consumers. [Note: All other and the following vehicle diagnostic, testing and information systems or vehicle diagnostic and service information systems are connected accordingly in the sequence described above.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing protective housing for control units in plenum chamber · 1 torque figures
• Removing and installing digital sound package control unit J525 · 1 torque figures
• Dismantling and assembling intake connecting pipe with potentiometer for exhaust gas recirculation G212 with exhaust gas recirculation valve N18, engine codes BLS, BRM · 1 torque figures
• Removing and installing exhaust gas recirculation cooler (engine codes BKC, BXE)
• 6-speed dual clutch gearbox 02E — Renew seal on selector shaft lever · 1 torque figures