Axle body metal-rubber bearing - replace — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

Don't miss

• Ensure proper bearing installation position (1) in the axle body (2) .

📋 Procedure

1. Lower the rear axle
2. Place and tension the separation device, for example, Kukko 15-2 from the bearing lining.
3. Install the remaining tools, as illustrated, and press the bearing.
4. Ensure proper bearing installation position (1) in the axle body (2) .
5. Place the bearing (2) in the axle body installation position and install the tools, as illustrated in the figures (I) .

6. Insert the bearing (2) in the axle body until dimension (a) is reached.
7. Remove the nut3301(5) and install the pressure bearing3301(6), as per illustration (II).
8. Insert the bearing (2) on the axle body (3) until the stop (arrow).
9. Fasten the rear axle under kerb weight conditions .
10. Install the wheels and tighten .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing jump start point with suppression filter C24
• Removing and installing oil pan, engine codes BLX, BLY, BLR
• Removing fuel delivery unit – VW Passat B6 2.0
• Removing seal – VW Passat B6 1.6 BSE/BSF
• Installing seals