Adjusting lid limit stop — VW
Adjusting lid limit stop on VW: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Slide adjustment buffer (1) in sealing channel on both sides and set upper dimension to… |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Fit rubber buffers onto both sides of lid.
- Install adjustment buffer (1) in sealing channel so that the adjustment buffer can still just be moved by hand.
- Slide adjustment buffer (1) to uppermost position (arrow).
- Close lid completely and open again.
- Slide adjustment buffer (1) in sealing channel on both sides and set upper dimension to (a) = 1...2 mm and tighten bolt (2). Prescribed torque: 10 Nm — 10 Nm (7.4 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing valve blocks for R36 leather sport seat – VW
- Removing and installing front exhaust pipes with catalytic converters and front silencers (vehicles with front-wheel drive)
- Installing gearbox - vehicles with 3.6 l - 206 kW engine – VW
- Installing gearbox - vehicles with 2.0 l - 103 kW TDI engine
- Removing injectors – VW 2.0 TDI
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.