Adjusting installation position of tail light: VW Sharan II / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

Don't miss

• Ensure that the tail light (3) lies flush against the surrounding components.

📋 Procedure

1. Turn light switch to "“0”" position.
2. Remove cover (1).
3. Twist plug (1) in (direction of arrow) and remove.
4. Loosen securing element (1) slightly.
5. Push down trim (2) in side panel on right of luggage compartment.

6. Loosen securing element (1) slightly.
7. Insert relevant Torx screwdriver into trim openings (2). [Note: Ensure that the tail light (3) lies flush against the surrounding components.]
8. Adjust installation position of tail light by screwing adjuster elements in or out.
9. Tighten securing element (1).
10. Insert cap (1) and turn against (direction of arrow).
11. Fit cover (1).
12. Tighten securing element (1).
13. Push up trim (2) in side panel on right of luggage compartment.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking vacuum hoses to non-return valve, solenoid valves N220 and N75, changeover valve N345 and vacuum reservoir
• Checking vacuum hoses and vacuum switch for rear differential lock F363
• Removing and installing floor covering, Multivan
• Removing and installing front swivel seat
• Removing and installing airbag unit on front passenger side, Transporter from 2010