Abdominal belt with double fastening (rear seat with longitudinal regulation) - removal and installation — VW

🧭 Before you start

Fits: VW Fox (5Z)

Don't miss

• The lining do not need to be removed from the padding.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the back seat .
2. Remove the seat's lining and padding . [Note: The lining do not need to be removed from the padding.]
3. Remove the fastening nuts (6) from the seat structure assembly (1) and from the seat's rail (4).
4. Remove the abdominal safety belt with simple fastening (5) and the double fastenings (2) from their respective studs (3), located in the structure of the seat rail (4).
5. Install the abdominal safety belt with simple fastening (5) and the double fastenings (2) to its respective studs (3), located in the seat rail's structure (4).
6. Install the seat rail's structure assembly (4) to the seat structure assembly (1) and fasten the fastening nuts (6) with torque of (30 Nm). — 30 Nm (22 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing alternator, 1.4 l, 103 kW TSI engine
• Removing and installing temperature flap control motor V68 (RHD)
• Removing and installing defroster flap control motor V107 and temperature flap control motor V68, LHD vehicles
• Removing and installing cowling with radiator fan V7 – VW CFNA
• Removing and installing alternator - vehicles with 1.0 l FSI engine