7-speed dual clutch gearbox 0AM — Removing and installing oil seals at clutch end — VW

🧭 Before you start

Fits: platform codes AV2, AV3, AY3

• Renewed: double clutch

📋 Procedure

1. Removing gearbox:
2. Removing dual clutch:
3. ⚠ It is essential to check the clutch in case of leaks. Renew double clutch if it is oily. — Remove outer oil seal.
4. Drive in outer, »new« oil seal with a plastic mallet until flush with clutch housing.
5. ⚠ Only drive in seal until it is flush with clutch housing, in order to avoid closing off oil drilling located behind it. Otherwise, ball bearing of outer input shaft can no longer be supplied with enough oil. — Unscrew spindle of oil seal extractor T10420.

6. Screw oil seal extractor T10420 into »small«, inner oil seal. Press oil seal extractor when doing this.
7. Now screw in spindle.
8. Pull out oil seal using spindle.
9. Drive in »new« oil seal up to stop.
10. Installing dual clutch:
11. Installing gearbox:

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Raising front wheel suspension to unladen position
• Raising rear wheel suspension to unladen position
• Removing and installing rear seat backrest, Multivan
• Removing and installing rear seat backrest, Transporter
• Removing and installing seat pan cover and padding, Multivan