6-speed dual clutch gearbox 02E — Removing and installing oil pump — VW

🧭 Before you start

Fits: VW Passat CC (357, 2008–2012), VW Sharan II / SEAT Alhambra (7N, 2010–), VW Touran I (1T, 2003–2015), VW Golf V / Jetta (1K, 2003–2009), VW Passat B6 (3C, 2005–2010), VW Golf VI (5K, 2008–2013); platform codes 5M1, 1F7, 137, 521

• Opens: engine oil

Don't miss

• Always use a new metal seal (B).

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove noise insulation General body repairs, exterior50Noise insulation; Assembly overview - noise insulation.
2. Remove lower part of front left wheel housing liner General body repairs, exterior66Wheel housing liner; Assembly overview - front wheel housing liner.
3. Position used oil collection and extraction unitV.A.G 1782 under gearbox.
4. Remove bolt (A) near pendulum support.
5. Remove this oil pipe.

6. Drain oil.
7. Screw overflow tube back in, torque setting: 3 Nm. — 3 Nm (2.2 lb-ft)
8. Renew seal (arrow) for plug.
9. Used oil collection and extraction unitV.A.G 1782 remains under gearbox.
10. Remove bolts (arrows) and remove oil cooler cover (A).
11. Remove bolts (arrows) and pull oil pump (1) off dowel pins and pull out oil pump drive shaft.
12. Push input shaft (A) for oil pump into gearbox as far as stop. Turn input shaft slightly whilst doing this.
13. Always use a new metal seal (B).
14. When fitting oil pump, observe splines of input shaft and proper seating of dowel pins.
15. Set new oil pump cover (A) in place and tighten new bolts (arrows) diagonally in several stages to 8 Nm. — 8 Nm (5.9 lb-ft)
16. Change oil and filter for dual clutch gearbox .
17. Install left wheel housing liner General body repairs, exterior66Wheel housing liners; Assembly overview - front wheel housing liner.
18. Install noise insulation General body repairs, exterior50Noise insulation; Assembly overview - noise insulation.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Dismantling and assembling differential: Gearbox codes: FNT, FLU, GAH
• Dismantling and assembling differential: Gearbox codes: GEQ, GSE, GEW, GSG
• Pressing front wheel bearing out and in
• Adapting fuel cut-off valve control unit to immobilizer control unit
• Valve case - assembly overview