5-speed manual gearbox 02R — Gearbox oil - check — VW
5-speed manual gearbox 02R — Gearbox oil - check on VW: 10 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code POLO
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 25 Nm (18 lb-ft) | Install bolt (arrow) and tighten |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove insulation tray below engine/gearbox, if fitted.
- Remove plug (arrow) to check oil.
- Install plug (arrow).
- Remove plug (arrow).
- Top up gearbox oil to lower edge of filler hole.
- Install plug (arrow).
- Start engine, engage gear and allow gearbox to turn for approx. 2 minutes.
- Switch off engine and remove plug (arrow).
- Top up gearbox oil to lower edge of filler hole.
- Install bolt (arrow) and tighten to 25 Nm. — 25 Nm (18 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing headlight dipped beam bulb M29/M31, halogen headlights H7, version 1
- Removing and installing ignition/starter switchD
- Removing and installing fuse holder CSC – VW Polo 6C
- Removing and installing luggage compartment floor
- Removing and installing shock absorber, "“Sport Select”" running gear
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.