4-speed automatic gearbox 01N — Removing and installing oil pan — VW

🧭 Before you start

Fits: VW Passat B5 (3B)

• Renewed: seal

Don't miss

• Cut open seal (arrow) with side-cutting pliers; always renew seal.
• Clean magnet in recess of pan. Ensure that magnet is seated correctly in pan.

📋 Procedure

1. Observe general repair instructions .
2. Remove noise insulation tray.
3. Place drip trayV.A.G 1306 underneath.
4. Remove plug (3).
5. Remove overflow pipe (2) and allow ATF to drain.

6. Unscrew oil pan bolts (1) in diagonal sequence and remove oil pan.
7. Cut open seal (arrow) with side-cutting pliers; always renew seal.
8. Clean magnet in recess of pan. Ensure that magnet is seated correctly in pan.
9. Install oil pan with new gasket.
10. Tighten pan bolts (1) diagonally in several stages bolt.
11. Install and bolt on overflow pipe (2).
12. Screw in plug (3) hand-tight with new oil seal.
13. Fill with 3 litres of ATF, check ATF level and top up .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Assembly overview, ABS/EDL/TCS/ESP Bosch 5.7 - hydraulic unit, brake servo/brake master cylinder
• Repairing rear brakes (disc brakes)
• Repairing rear brake caliper
• Assembly overview of rear axle with four-wheel drive
• Removing and installing injection system components – VW BJR