8-speed automatic gearbox 0C8 — Removing and installing oil pan — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

• Opens: gearbox oil

Don't miss

• Clean all magnets in recesses of oil pan. Make sure that magnets make full contact with oil pan.
• Ensure that all spacer sleeves (2) are completely located in new gasket (1).
• After installing, fill up ATF, check ATF level and top up .

📋 Procedure

1. Remove gearbox noise insulation.
2. Place drip trayV.A.G 1306 underneath.
3. Unscrew and remove ATF inspection plug (A).
4. Unscrew and remove overflow pipe (C).
5. Drain ATF.

6. Unscrew oil pan bolts (2) in diagonal sequence and remove oil pan.
7. Clean all magnets in recesses of oil pan. Make sure that magnets make full contact with oil pan.
8. Install oil pan with new gasket (1).
9. Ensure that all spacer sleeves (2) are completely located in new gasket (1).
10. Tighten oil pan bolts diagonally in several stages.
11. Install overflow pipe (C).
12. Install ATF inspection plug (A).
13. After installing, fill up ATF, check ATF level and top up .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing alternator, 12-cyl. 6.0 l injection engine
• Installing adjustment motor – VW Touareg I · 1 torque figures
• Removing and installing Lambda probe G39 and Lambda probe 2G108
• Checking vacuum unit for intake manifold flaps – VW
• Checking fuel pump non-return valve, engine code BGU – VW BGU