DPF removal: Volvo D 5244 T only renewal 2.4 TD (D5244T10, D5244T11, D5244T13, D5244T14, …)

Step-by-step DPF removal for the Volvo D 5244 T only renewal 2.4 TD: 16 steps. What to remove, in what order, and what to check after.

Workshop procedure for VOLVO — the exact step sequence and torque figures, straight from real workshop data.

16 steps 15 engine codes

🧭 Before you start

Fits: platform codes 2.4, 20V, D5, |, TD, 2.4D, D3, (2.4D)

🔧 Engine codes this applies to

D5244T10 D5244T11 D5244T13 D5244T14 D5244T15 D5244T16 D5244T17 D5244T18 D5244T19 D5244T4 D5244T5 D5244T6 D5244T7 D5244T8 D5244T9

📋 Procedure

Preparation and removal

Raise the vehicle
Remove the bracket
Exhaust gas temperature sensor
Remove the temperature sensor
Disconnect the pressure line(s)

D5244T10? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →

Remove the nuts shown
Remove the diesel particulate filter

Installation and checks

Renew the gaskets
Renew the nuts
Refit the diesel particulate filter
Refit the exhaust to the rubber mounting rings
Refit the exhaust gas temperature sensor
Initialise the diesel particulate filter settings
Use the diagnostic tool
Change the engine oil

Other VOLVO procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.