TorqFix

Timing chain replacement: Toyota Corolla 2001 (1ND-TV)

Step-by-step timing chain replacement for the Toyota Corolla 2001 (1ND-TV): 78 steps. What to remove, in what order, and what to check after.

Workshop procedure for TOYOTA — the exact step sequence and torque figures, straight from real workshop data.

78 steps 1 engine code engine codes merged from 2 documented variants

🧭 Before you start

Fits: platform codes 1.4, D4-D

  • Opens: coolant
  • Timing position: the crankshaft or camshaft is set and locked during this job
  • Special tools named: locking pin
  • Renewed: crankshaft oil seal

Don't miss

  • If the timing chain is to be re-used, mark the running direction before removal
  • Use the special tool to counterhold

🔧 Engine codes this applies to

📋 Procedure

Preparation and removal

  1. If the timing chain is to be re-used, mark the running direction before removal
  2. Remove the right-hand front wheel
  3. Timing chain cover:
  4. Note: Avoid bending, torsion or traction
  5. Remove the engine upper cover
1ND-TV? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove the coolant pump pulley
  2. Disconnect the camshaft position sensor(s)
  3. Turn the crankshaft to TDC for cylinder 1
  4. Align the crankshaft timing marks
  5. Align the camshaft timing marks
  6. If the marks are misaligned, rotate the engine 1 turn
  7. Remove the crankshaft pulley
  8. Counterhold tool:
  9. Use the special tool to counterhold
  10. Support the engine with a lifting jack
  11. Note: Use a wooden block to support the engine
  12. Remove the right-hand engine support
  13. Remove the right-hand engine support bracket
  14. Remove the upper timing cover
  15. Remove the timing chain cover
  16. Align the holes on the locking arm and automatic tensioner
  17. Apply pressure to the tensioner
  18. Lock the chain tensioner with a locking pin
  19. Remove the chain tensioner
  20. Remove the chain tensioner rail(s)
  21. Remove the chain guide rail
  22. Use a special tool
  23. Remove the camshaft gearwheel
  24. Use the special tool to counterhold
  25. Remove the timing chain and gearwheels together

Installation and checks

  1. Align the coloured chain link with the marks on the gearwheels
  2. After applying liquid sealant:
  3. Refill the cooling system
  4. Check the cooling system for leaks
  5. Valve cover
  6. Check the engine for oil leaks
  7. Camshaft gearwheel
  8. Renew the seals
  9. Renew the O-rings
  10. Renew the crankshaft oil seal

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.