Ancillary belt M9R (Megane2) — RENAULT

🧭 Before you start

Fits: platform codes 2.0, DCI, 130, FAP, |, 150, 175, RS

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: locking pin
• Renewed: tensioner

Don't miss

• The ancillary drive belt can only be fitted once. When removal is required, always fit a new belt

🔧 Engine codes this applies to

📋 Procedure

Preparation and removal

1. Note: The ancillary drive belt can only be fitted once. When removal is required, always fit a new belt
2. Disconnect the battery earth cable
3. Disconnect the positive battery cable
4. Raise the vehicle
5. Remove the engine lower cover

6. Remove the front right wheel
7. Remove the right-hand inner wing splash guard
8. Remove the reinforcement plate on the lower cross member

Installation and checks

9. Turn the tensioner pulley clockwise until the locking pin fits
10. Use a wrench
11. Refit all other parts in the reverse order of removal
12. Renew the idler pulley
13. Renew the tensioner

Other RENAULT procedures

• Renault non type specific 2.0 dCi timing chain replacement
• Renault Laguna V6 timing chain replacement
• Renault G8T-714/G8T-716 timing belt replacement
• Renault Laguna II F5R-700 timing belt replacement
• G8T version with cam belt only (Laguna I) refit + multi tiff included MB 25-03-05 Dialogis
• Renault G8T-706 timing belt replacement
• G9T_2.2_dci_fuel pump timing
• Renault Clio I Wiliams F7R-700 timing belt replacement
• Ancillary belt K4M, K4J
• Ancillary belt M9R (Laguna3)