TorqFix

807 DW12ATED4 drive belt check — PEUGEOT

807 DW12ATED4 drive belt check on Peugeot: 18 steps. What to remove, in what order, and what to check after.

Workshop procedure for PEUGEOT — the exact step sequence and torque figures, straight from real workshop data.

18 steps

🧭 Before you start

Fits: platform codes 2.2, HDIF, 16V

  • Timing position: the crankshaft or camshaft is set and locked during this job
  • Special tools named: locking pin

📋 Procedure

  1. Check the drive belt tension
  2. Tensioner locking pin:
  3. Renew the ancillary drive belt
  4. Remove the front right wheel
  5. Remove the wheel arch cover lining
PEUGEOT? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove the undertray
  2. Fit the special tool
  3. Turn the tensioner anti-clockwise
  4. Fit the special tool
  5. Remove the drive belt
  6. Check the condition of the tensioner and idler pulley(s)
  7. Fit a new belt
  8. Remove the special tools
  9. Turn the engine 4 times by hand
  10. Check the belt tension mark
  11. Further refitting is in the reverse order of removal

Other PEUGEOT procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.