Supporting engine in installation position - engine codes CUKB, CXUA — AUDI

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

• Special tools named: T40091/3

Don't miss

• If adapter 10-222A/4 does not yet have hole (marked with (arrow)), hole must now be drilled into adapter.
• Disregard (item 1).
• Tighten spindles 10-222A/11 slightly to take up weight of engine/gearbox assembly; do not lift.
• High voltage can cause fatal injury.Danger of severe or fatal injuries from electric shock.The high-voltage system must be re-energised by a "“high-voltage technician”". — Re-energise high-voltage system .

🔧 Engine codes this applies to

📋 Procedure

1. If adapter 10-222A/4 does not yet have hole (marked with (arrow)), hole must now be drilled into adapter.
2. ⚠ High voltage can cause fatal injury.Danger of severe or fatal injuries from electric shock.The high-voltage system must be de-energised by a "“high-voltage technician”".Work on the de-energised high-voltage system may only be performed by an "“electrically instructed person”". — De-energise high-voltage system .
3. Remove power and control electronics for electric driveJX1.
4. Remove plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.
5. Remove engine cover panel .

6. Detach cover caps on bolted connections for suspension struts (front).
7. Position 10-222A/31-1 and 10-222A/31-2 on mountings for suspension struts.
8. Fit adapter10-222A/4 with T40091/3, as shown in illustration.
9. Remove bolt (2). [Note: Disregard (item 1).]
10. Set up further tools on left side of engine compartment as shown in illustration.
11. Screw bolt M12x1, 5x95 (item 1) with lifting eye (2) from lifting tackle2024A several turns into gearbox and attach hook of spindle10-222A/11.
12. Set up further tools on right side of engine compartment as shown in illustration.
13. Attach hook of spindle10-222A/11 to engine lifting eye (right-side).
14. Tighten spindles 10-222A/11 slightly to take up weight of engine/gearbox assembly; do not lift.
15. Install engine cover panel .
16. Install plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.
17. Install power and control electronics for electric driveJX1.
18. ⚠ High voltage can cause fatal injury.Danger of severe or fatal injuries from electric shock.The high-voltage system must be re-energised by a "“high-voltage technician”". — Re-energise high-voltage system .

Other AUDI procedures

• Removing and installing hybrid battery unitAX1 – Audi A3 · 1 torque figures
• Checking holding pressure, engine code CWVA
• Draining and filling cooling system - engine cooling system
• Removing and installing fuel tank - vehicles with front-wheel drive and multi-link suspension
• Installing engine - all engine codes except CUKB, CXUA – Audi
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures