Renewing oil seal for flange shaft (right-side) with gearbox installed — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

• Renewed: circlip for flange shaft

Don't miss

• Always renew circlip for flange shaft.

📋 Procedure

1. Remove front right wheel.
2. Release quick-release fasteners (1) and (2) and detach noise insulation panels.
3. Remove noise insulation (1) in wheel housing (right-side).
4. Detach drive shaft (right-side) from flange shaft and tie up as far forwards as possible, taking care not to damage surface protection.
5. Place used oil collection and extraction unitV.A.G 1782 underneath.

6. Remove flange shaft (right-side); to do so, secure puller T10037 to gearbox housing (arrow).
7. Lever out flange shaft oil seal (arrow) using a suitable lever.
8. Always renew circlip for flange shaft.
9. Clamp flange shaft in vice, using jaw protectors. Use new circlip (A) to press old circlip out of groove in flange shaft.
10. Lightly oil outer circumference of new oil seal.
11. Drive in new flange shaft oil seal using thrust piece T10387 until thrust piece reaches stop; keep seal straight when installing. [Note: Driving-in depth (standard): 5.5 mm beneath surface of housingWhen carrying out a repair, the oil seal is driven in to a depth of 6.5 mm using thrust piece T10387, so that the new seal does not bear on the same contact surface on the used flange shaft.]
12. Pack space between sealing lip and dust lip half-full with sealing greaseG 052 128 A1.
13. Knock flange shaft in with driftVW 295.
14. Bolt drive shaft to flange shaft Running gear, front-wheel drive and four-wheel drive40.
15. Check oil level in gearbox and top up with gear oil if necessary .
16. Install noise insulation for drive shaft and noise insulation below gearbox.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing seat rake adjustment motor - seat with seat memory/electric adjustment · 1 torque figures
• Removing and installing trim panel for rear fog light and number plate light
• Running gear, front-wheel drive and four-wheel drive — Wheel bearing: exploded view · 1 torque figures
• Adjusting toe setting at rear wheels (four-wheel drive vehicles) · 1 torque figures
• Removing and installing wheel bearing housing (aluminium) - four-wheel drive