Removing and installing seat rake adjustment motor - seat with seat memory/electric adjustment — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove seat .
2. Unplug connector (2).
3. Remove bolts (3) (3x). Tightening torque: 4 Nm — 4 Nm (3.0 lb-ft)
4. Motor (1) has no basic position; motor and seat can be in any position when removing and installing.
5. A wiring adapter may be required, depending on motor being installed .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing gearbox - vehicles with 1.4 ltr. TFSI and 2.0 ltr. TFSI engine
• Removing and installing fuel pressure sender G247 / G624 · 2 torque figures
• 6-cylinder direct injection engine with supercharger (3.0 ltr. 4-valve TFSI), mechanics — Separating engine from automatic gearbox 09L · 1 torque figures
• Removing and installing starter - vehicles with 6.3 ltr. FSI engine
• Draining and filling cooling system - vehicles with hybrid drive