Removing and installing wheel bearing housing (aluminium) - four-wheel drive — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

Don't miss

• Mark installation position of eccentric washer for bolt (B).

📋 Procedure

1. Remove hexagon socket head bolt for drive shaft .
2. Remove wheels.
3. Remove securing bolts (1) from brake caliper.
4. Take off brake caliper and tie up on body.
5. Remove brake disc.

6. Remove hexagon socket head bolt (1).
7. Pull ABS speed sensor (2) out of wheel bearing housing.
8. Remove bolt (1) for coupling rod.
9. Remove bolt (A) for track rod.
10. Mark installation position of eccentric washer for bolt (B).
11. Remove bolt (B).
12. Remove bolt (2) for transverse link (1).
13. Pull wheel bearing housing off drive shaft.
14. Removing and installing drive shaft
15. Check and adjust wheel alignment .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing sunroof sun blind (rear) – Audi A3
• Removing undamaged rear window – Audi A6/A7 C7
• Removing and installing high-pressure sender G65 – Audi R8 · 2 torque figures
• Checking air quality sensor G238
• Renewing selector shaft oil seal – Audi A3 · 1 torque figures