Removing and installing trim panel for rear fog light and number plate light — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Before tightening bolts and nuts, align trim panel for rear light with rear lid contours (even shut lines).

📋 Procedure

1. Switch off ignition and remove ignition key.
2. Turn light switch to "“0”" position.
3. Remove number plate.
4. Remove the rear lid trim 70.
5. Remove the lower rear lid trim 70.

6. Turn left bulb carrier (1) anti-clockwise and right bulb carrier (2) clockwise.
7. Take out bulb carriers.
8. Screw out bolts and unscrew nuts (arrows).
9. Unplug connector (3).
10. Use flat screwdriver to press fasteners at operating levers (1) in (direction of arrow).
11. Pull operating levers downwards out of handle mechanism (2).
12. Take trim panel for rear fog light and number plate light out of rear lid.
13. Before tightening bolts and nuts, align trim panel for rear light with rear lid contours (even shut lines).
14. Fit the rear lid trim 70.
15. Fit the lower rear lid trim 70.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing bonded rubber bush for wheel bearing housing - Audi S1
• Removing and installing temperature flap control motor V68 and defroster flap control motor V107
• Removing and installing fresh air and air recirculation flap control motor V154
• Draining and filling gear oil - 5-speed manual gearbox 0A4
• Removing and installing lumbar support adjustment unit – Audi