Renewing needle bearings (polygon bearings) for flange shaft (right-side) — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

📋 Procedure

1. Remove flange shaft (right-side) .
2. Assemble assembly tool T10047, as shown in illustration.
3. Screw parts together as far as stop.
4. Remove circlip (A).
5. Rotate shaft when pressing off (arrow) to prevent contact surface of needle bearings on shaft from being damaged.

6. Remove seal (A) from groove (arrow).
7. Lightly lubricate seal (A) with gear oil.
8. Fit seal (A) in groove (arrow) on flange shaft.
9. Fit clamp T10047.
10. Rotate shaft when pressing on (arrow) to prevent contact surface of needle bearings on shaft from being damaged.
11. Secure needle bearings in position with new circlip.
12. Install flange shaft (right-side) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing anti-roll bar – Audi A8 D3 · 4 torque figures
• Installing gearbox, vehicles with 1.8 ltr. and 2.0 ltr. TFSI engine · 4 torque figures
• Removing and installing navigation system with CD drive control unit J401 · 6 torque figures
• Removing and installing exhaust manifold (left-side) – Audi · 4 torque figures
• Removing gearbox - vehicles with 4-cylinder TDI engine – Audi · 2 torque figures