Renewing needle bearings and flange shaft oil seal (right-side) — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

Don't miss

• Make sure that seal is not twisted.

📋 Procedure

1. Remove flange shaft (right-side) .
2. Screw parts together as far as stop.
3. Remove circlip (A) for needle bearings.
4. To prevent damage to contact surface of needle bearings on shaft, rotate shaft (arrow) when pressing on.
5. Remove old oil seal (A) from groove (arrow).

6. Lubricate new oil seal (A) lightly with gear oil and install. [Note: Make sure that seal is not twisted.]
7. Attach clamp T10047 to flange shaft .
8. To prevent damage to contact surface of needle bearings on shaft, rotate shaft (arrow) when pressing off.
9. Secure needle bearings on flange shaft with a new circlip.
10. Install flange shaft (right-side) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing turbocharger control unit J724
• Checking fuel system pressurisation pump G6 - vehicles with 4-cyl. engine
• Removing and installing turbocharger 1 control unit J724 - vehicles with engine codes CDUD, CPNB, CTBA and CTBC
• Checking fuel system pressurisation pump G6 - TDI vehicles
• Adjusting selector mechanism (vehicles from 05.99 to 11.00)