Renewing needle bearing (polygon bearing) for right flange shaft, and seal on right flange shaft — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. Remove right flange shaft .
2. Fit clamp T10047 so that marks "“B”" on both parts of it are facing one another.
3. Screw both parts together up to stop.
4. Remove retaining ring (A) for bearings.
5. Remove seal (A) from groove (arrow) and renew.

6. Moisten seal (A) with gear oil.
7. Insert seal (A) in groove (arrow) in flange shaft.
8. Fit clamp T10047 onto flange shaft ⇒ fig. N39-10212 .
9. To avoid damage to running surface of bearing on shaft, turn shaft during pressing procedure (arrow).
10. Secure bearing with a new retaining ring.
11. Install right flange shaft .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling clutch "“C”"
• Removing and installing fuel delivery unit/fuel gauge sender, vehicles up to model year 2012
• Removing and installing alternator - Audi TT with 2.0 ltr. TDI engine
• Removing left cylinder head – Audi A8 D2
• Removing and installing right (front passenger side) heat exchanger · 1 torque figures