Renewing front bonded rubber bushes in rear final drive carrier — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E)

• Special tools named: puller

📋 Procedure

1. Remove rear final drive with rear final drive carrier 6-speed manual gearbox 0A5 four-wheel drive39Installing and removing rear final drive.
2. Remove final drive carrier from final drive.
3. Push thrust plateVW 401 under edge (B) to stop against rear final drive carrier.
4. Press out bonded rubber bush (C) via puller (A) opposite the direction of pressing in.
5. Before pressing in, coat rubber bead of bonded rubber bush with lubricant, e.g., soft soap.

6. Position bonded rubber bush with flat surfaces (arrows 1) in installation position. The lugs (arrow 2) face indirection of travel (arrow).
7. Set clamp40 - 204 A on bonded rubber bush (A) so the lugs will not be damaged.
8. Press in the bonded rubber bush to stop.
9. Lever rubber bead of bonded rubber bush (A) out after pressing work is completed.
10. Attach rear final drive carrier to rear final drive and install in vehicle 6-speed manual gearbox 0A5, four-wheel drive39Removing and installing rear final drive.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures