Removing and installing Y-thermostat . — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2FC

• Opens: coolant

🔧 Engine codes this applies to

📐 25 workshop diagrams for CKTB

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove air filter .
2. Remove any noise insulation General body repairs, exterior66Exterior equipment; Noise insulation.
3. Drain coolant .
4. Loosen clip (2) from exhaust gas recirculation cooler (3) and pull coolant hose (1) off.
5. Loosen clip (2) and pull coolant hose (1) off.

6. Loosen clip (2) and pull coolant hose (1) off.
7. Release coolant hoses from retainers.
8. Remove Y-thermostat together with hoses.
9. Clip coolant hoses into retainers.
10. Replenish coolant .
11. Install air filter .
12. Install any noise insulation General body repairs, exterior66Exterior equipment; Noise insulation.

Other AUDI procedures

• Removing and installing coolant circulation pump V50 · 1 torque figures
• Assembly overview - sealing flange, belt pulley end · 2 torque figures
• Removing and installing engine control unit J623 with protective housing
• Checking hydraulic compensation elements
• Checking fuel filter
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures