Removing and installing wiring junctionTV1 - vehicles with high-voltage system — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018)

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off (see the separate procedure).
2. Remove supply air duct for drive battery Heating, air conditioning 87. Battery cooling module.
3. Release retaining spring (2) and open flap (1) above wiring junction.
4. Disconnect electrical wiring (3, 4, 5).
5. Remove nuts (arrows).

6. Move wiring junction (6) as far upwards as possible.
7. Disconnect electrical wiring (2, 3).
8. Remove positive cables (1, 4).
9. Detach wiring junction.
10. If wiring junction is renewed:
11. Connect batteries. Steps required (see the separate procedure).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing earth cable with battery monitor control unit J367, battery in engine compartment (version 2)
• Removing and installing starter - vehicles with 2.5 ltr. TFSI engine and dual clutch gearbox
• Removing and installing headlight range control motor V48/V49 - gas discharge headlights (version 1) up to model year 2014
• Removing and installing headlight range control motor V48/V49 - gas discharge headlights (version 2) up to model year 2014
• Removing and installing relay and fuse holder BSB in electronics box