Removing and installing wiper frame with linkage and wiper motor — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Deactivate APP function .
2. Move windscreen wipers to park position. Then, switch off ignition and all electrical loads, and pull out ignition key.
3. Disconnect battery .
4. Remove plenum chamber cover General body repairs, exterior66Removing and installing plenum chamber cover.
5. Removing wiper arm .

6. Undo and remove bolts (arrows) securing trim (1).
7. Remove trim (1) from vehicle.
8. Release and disconnect electrical connector (1).
9. Unscrew securing bolts (arrows) and remove wiper frame (2) towards front from vehicle.
10. When installing, fit guide pin located on back of wiper frame into grommet (arrow) on plenum chamber bulkhead.
11. Tighten bolts securing wiper frame to body to 8 Nm. — 8 Nm (5.9 lb-ft)
12. Push connector onto connection of wiper motor and engage it.
13. Install air duct trim.
14. Connect battery .
15. Install plenum chamber cover General body repairs, exterior66Removing and installing plenum chamber cover.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures