Removing wiper frame with linkage and wiper motorV: VW Touareg I

🧭 Before you start

Fits: VW Touareg I (7L, 2002–2010)

Don't miss

• If the wiper motor control unit J400 or the windscreen wiper motorV is replaced, the wiper motor control unit J400 has to be coded .

📋 Procedure

1. ⚠ When batteries are reconnected, the procedure described in the workshop manual must be strictly followed . If the sequence is not maintained, the battery isolator may be triggered and the electrical equipment of the vehicle may be damaged.Observe notes for battery terminal clamp bolt . — Disconnect battery .
2. Remove wiper arm on driver side .
3. Remove wiper arm on front passenger side .
4. Remove plenum chamber cover General body repairs, exterior64Flush bonded windows; Removing and installing plenum chamber cover; Removing.
5. Remove M6 hexagon socket head bolt (1).

6. Remove bolts (1).
7. Unclip wiring/line retainers (1) from wiper frame.
8. Pull connector off windscreen wiper motorV.
9. ⚠ The retaining tab is not readily accessible on right-hand drive vehicles.The retaining tab may be damaged.The retaining tab is not to be forced open. — Remove M6 hexagon socket head bolts (2) and washers located beneath.
10. Remove wiper frame with linkage upwards out of vehicle. [Note: If the wiper motor control unit J400 or the windscreen wiper motorV is replaced, the wiper motor control unit J400 has to be coded .]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures