Removing and installing wiper arm, vehicles with rear lid — AUDI

🧭 Before you start

Fits: platform codes SF, SG

📋 Procedure

1. Switch on ignition.
2. Actuate "“rear window wipe”" function and allow wiper arm to move to its end position.
3. Switch off ignition and remove ignition key.
4. Press together cap of rear window wiper (1) in direction of arrow (A).
5. Fold up cover cap in direction of arrow (B) to unclip.

6. Remove spray jet .
7. Loosen securing nut of wiper arm by one turn.
8. Fit an M6 nut on top of securing nut.
9. Fit puller T10369/5 to wiper arm (2).
10. Fit thrust piece (3) to wiper shaft.
11. Screw in bolt (1) until wiper arm has been pulled off the wiper shaft.
12. Unscrew nut (4) completely and remove wiper arm.
13. Fit rear window wiper arm, and screw securing nut loosely onto wiper arm shaft.
14. Adjust rear window wiper park position .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing auxiliary battery – Audi A8 D4
• Replacing sealing strip – Audi A8 D4
• Raising suspension to reference position before tightening bolts
• Checking emergency exit battery voltage – Audi A8 D4
• Removing lock cylinder