Adjusting wiper arm: VW Polo 6C

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

Don't miss

• The dimension (a) indicates the distance between the tip of the wiper blade and the lower edge of the rear window.

📋 Procedure

1. Remove wiper arm .
2. Switch on ignition.
3. Move wiper lever to "“rear window wipe”" position.
4. Switch off ignition.
5. Fit wiper arm together with attached wiper blade onto wiper shaft.

6. Align wiper blade as follows on rear window: [Note: The dimension (a) indicates the distance between the tip of the wiper blade and the lower edge of the rear window.]
7. Tighten wiper arm nut.
8. Activate "“rear window wipe”" function on wiper lever, and allow wiper arm to move to its end position.
9. Switch off ignition.
10. Check wiper arm adjustment again, and correct it if necessary.
11. Press cap onto wiper arm.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Assembly overview - sump / oil pump, engine codes CBAA, CBAB, CBAC, CBBA, CBBB
• Removing and installing side airbag crash sensor on driver side G179/G180
• Removing and installing alternator C, vehicles with 1.4 l TSI engine
• Assembly overview - seals in bevel box and stub shaft bearing in bevel box
• Part I: chain drive - engine codes AQP and AUE - assembly overview