Removing and installing wiper arm: Audi A3

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

📋 Procedure

1. Switch on ignition.
2. Actuate "“rear wiper”" and allow wiper arm to move to end position.
3. Switch off ignition.
4. Versions equipped with mechanical ignition lock: Remove ignition key.
5. Versions equipped with electronic ignition lock: Deposit ignition key outside of vehicle.

6. Carefully pry cap apart slightly (arrows) and lift off.
7. Carefully pull off washer jet (2).
8. Slacken nut (1) one turn.
9. Place an M6 nut (4) on top of nut.
10. Apply puller T10369/1 at wiper arm (1) as shown in illustration.
11. Apply thrust piece (2) at wiper shaft.
12. Turn bolt (3) clockwise until wiper arm is clear of wiper shaft.
13. Remove nut and detach wiper arm.
14. Adjust wiper arm .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing steering column electronics control unit J527, version with mechanical ignition lock
• Fitting location of remote control receiver for auxiliary/supplementary heater
• Exploded view - poly V-belt drive for vehicles with hydraulic power steering
• Exploded view - front brake, steel version brakes (1LU)
• Checking pressure signal at high-pressure sender G65