Removing and installing washer pump V5: Audi A3

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Remove front section of front right wheel housing liner 66.
3. Remove fog light .
4. Remove noise insulation 50.
5. Remove closure plate for bumper cover 63.

6. Unplug electrical connector (4).
7. Place drip tray under washer fluid reservoir.
8. Release retaining clip (1) in direction of (arrow) and disconnect washer fluid hose (2) from washer pump.
9. Lift washer pump V5(item 3) out of washer fluid reservoir.
10. Check sealing grommet (1) for damage.
11. Slide washer pump V5(item 2) into washer fluid reservoir from above; washer pump is guided by two retaining lugs (arrows).
12. Install fog light .
13. Install noise insulation 50.
14. Install closure plate for bumper cover 63.
15. Install front section of front right wheel housing liner 66.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuse and relay carrier in plenum chamber electronics box (driver's side)
• Checking fuel system pressurisation pump G6/fuel pump G23, vehicles with 6.0 ltr. (V12) engine
• TDI injection and glow plug system (8-cyl. 4.2 ltr. 4-valve common rail) — Bleeding fuel system (engine codes CCFA and CCFC)
• Removing and installing bottom section of intake manifold (right-side), cylinder bank 1
• Removing and installing cover for shift unit – Audi Q7