Removing and installing cover for shift unit: Audi Q7

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• The centring bracket is only required for production purposes.
• Fit rubber sleeve (arrow) for selector lever cable and make sure it is seated properly all round on cover for shift unit.

📋 Procedure

1. Remove shift unit .
2. Press rubber sleeve (arrow) forwards out of cover for shift unit.
3. Detach retaining hooks (1) and (2).
4. Remove bolts (arrows).
5. Move cover for shift unit (1) slightly towards rear and unscrew bolts (arrows) for centring bracket (2).

6. Lift off cover for shift unit.
7. Lift off centring bracket (does not have to be re-installed). [Note: The centring bracket is only required for production purposes.]
8. Fit cover for shift unit into opening from the top.
9. Fit selector lever cable (3) through opening in on cover for shift unit.
10. Secure bolts (arrows).
11. Insert retaining hooks (1) and (2).
12. Fit rubber sleeve (arrow) for selector lever cable and make sure it is seated properly all round on cover for shift unit.
13. Install shift unit .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view of suspension strut and drive shaft
• Checking camshaft adjustment valve – Audi 1.8 ADR
• Detaching toothed belt from camshaft sprocket 08.91 ä
• Checking the function of the positioning motor for fresh/recirculated air flap -V154 and switch -E159
• Removing and installing head airbag - 5-door vehicles