Removing and installing torque reaction support: Audi A6 C6 (ASB, AUK, BDX, BKH, …)

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

• Opens: coolant
• Renewed: o-rings

Don't miss

• Renew the bolts tightened with specified tightening angle.Renew O-rings.

🔧 Engine codes this applies to

📐 20 workshop diagrams for ASB

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Drain off coolant .
2. Remove bolts (arrows) for torque reaction support.
3. Place drip tray for workshop hoistVAS 6208 under engine.
4. Remove bolts (arrows).
5. Detach front coolant pipe from engine and coolant pump.

6. Remove torque reaction support. [Note: Renew the bolts tightened with specified tightening angle.Renew O-rings.]
7. Move torque reaction support to installation position.
8. Install coolant pipe (front) .
9. Install stop for torque reaction support to allow rubber buffer for torque reaction support to rest at top and bottom without play and then tighten bolts (arrows).
10. Fill cooling system .

Other AUDI procedures

• Removing and installing camshafts - cylinder head (left-side)
• Removing and installing flywheel · 3 torque figures
• Separating engine from multitronic gearbox · 1 torque figures
• Installing high-pressure pipes – Audi A6 C6 · 2 torque figures
• Removing and installing coolant pipe (front) – Audi TT Mk2
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures