Removing and installing tank for reducing agent — AUDI

🔧 Engine codes this applies to

📋 Procedure

1. Remove air filter housing .
2. Remove front bumper cover General body repairs, exterior63Front bumper; Removing and installing bumper cover.
3. Remove front left wheel housing liner General body repairs, exterior66Wheel housing liner; Removing and installing front wheel housing liner.
4. Emptying tank for reducing agent .
5. Seal all open connections using clean plugs from engine bung setVAS 6122.

6. Disconnect connectors (1).
7. Press release tab (3).
8. Pull off delivery line (2).
9. Place engine and gearbox jackVAS 6931 equipped with a soft foam padding under tank for reducing agent (1) to support the tank.
10. Remove nuts (1).
11. Carefully lower tank for reducing agent (2) using engine and gearbox jackVAS 6931.
12. Additionally support tank for reducing agent by hand while doing so.
13. Ensure lines are secured properly by pulling.
14. Check that all lines are clipped into tank for reducing agent.
15. Connect .
16. Switch ignition on.
17. Adapt SCR system learnt values , 01 - Systems capable of self-diagnosis, 01 - Diesel direction injection and preglow system EDC 17, 01 - Engine electronics functions, 01 - Adapting SCR system learnt values.
18. Follow further instructions displayed on .

Other AUDI procedures

• Emptying tank for reducing agent
• Removing and installing fuel pressure regulating valve, version 1
• Removing and installing fuel tank, front-wheel drive
• Removing and installing upper toothed belt guard
• Removing and installing cooler for charge air cooling circuit
• Removing and installing toothed belt · 56 torque figures
• Removing engine · 41 torque figures
• Removing camshaft timing chain from camshafts · 38 torque figures
• Installing engine · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures