Removing and installing starter - Audi TT with 3.2 ltr. MPI engine and manual gearbox — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Detach resonance pipe (2) from air hose.
3. Detach air hose (1) from throttle valve module J338.
4. Unplug electrical connector (3) for air mass meter G70.
5. Unbolt air cleaner (top section) (arrow) and take out air filter element.

6. Remove bolts (arrows) and detach air duct.
7. Unbolt air cleaner (bottom section) (arrows).
8. Unplug connector (4) by sliding locking element to rear and pressing down release catch.
9. Cut through cable ties.
10. Fold back protective sleeve (3) and detach B+ wire (item 5) from solenoid switch.
11. Unscrew earth cable (2).
12. Remove upper starter bolt (1).
13. Unscrew nut (3) from lower starter bolt and detach bracket (2) for wiring harness.
14. Remove lower starter bolt (1) (accessible from above) and detach starter.
15. Install air cleaner housing 24Air cleaner; Exploded view - air cleaner housing.
16. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Tightening torques
• Removing and installing ribbed belt
• Check solenoid valve for boost pressure limitation -N75
• Belt drive for alternator, coolant pump, and vane pump
• Removing and installing intake manifold -engine codes AAD, ABB-