Removing and installing starter - Audi TT RS with 2.5 ltr. TFSI engine and manual gearbox — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove air cleaner housing 24Air cleaner; Exploded view - air cleaner housing.
3. Unplug connector (2) by sliding locking element to rear and pressing down release catch.
4. Fold back protective sleeve (1) and detach B+ wire (item 3) from solenoid switch.
5. Remove noise insulation (front) (1)General body repairs, exterior66Noise insulation; Exploded view - noise insulation.

6. Remove nuts (2) and detach bracket (1) for wiring harness.
7. Remove bolts (arrows) for starter.
8. Remove starter (1) downwards.
9. Install air cleaner housing 24Air cleaner; Exploded view - air cleaner housing.
10. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Automatic gearbox 01L, four-wheel drive — Removing and installing gearbox - vehicles with 8-cylinder petrol engine
• Audi 1.8 gearbox removal & installation
• Removing and installing cylinder head cover – Audi TT Mk1
• Removing and installing exhaust manifold – Audi TT Mk1
• Installing sump (top section) - engines with moulded gasket · 4 torque figures