Removing and installing side trim (sill side): Audi A6 C6

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Mark electrical connectors (2) and (3) for re-installation and unplug.
• Make sure that side trim (sill side) (1) is engaged correctly in seat pan and backrest (arrows).

📋 Procedure

1. Remove seat .
2. Attach seat repair standVAS 6136 to engine and gearbox supportVAS 6095.
3. Attach front seat to seat repair standVAS 6136.
4. Remove outer side trim .
5. Remove bolt (2).

6. Detach seat height adjustment handle (1) in direction of (arrow).
7. Remove backrest adjuster knob .
8. Remove backrest cover panel (left-side) .
9. Remove bolt (1).
10. Sever cable tie.
11. Release retaining tabs and take electrical connectors out of brackets.
12. Mark electrical connectors (2) and (3) for re-installation and unplug.
13. Push in pin to detach fastener (3).
14. Release retaining tab (1)(arrow A) and lift off side trim (sill side) (2) towards front (arrows B).
15. Unplug electrical connector for lumbar support.
16. Make sure that side trim (sill side) (1) is engaged correctly in seat pan and backrest (arrows).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel pump delivery rate - vehicles with 10-cylinder TFSI engine (Audi RS6)
• Removing and installing sliding headliner – Audi A8 D3
• Installing gearbox in vehicles with V6 petrol engine – Audi
• Removing and installing side airbag igniters N199 and N200, front (standard seats, seats with electric adjustment) - vehicles up to approx. 04.2007
• Removing and installing conventional clutch – Audi A3 · 1 torque figures