Removing and installing secondary air pump motor V101 - R8 Coupé — AUDI

🧭 Before you start

Fits: platform code 42

🔧 Engine codes this applies to

📐 1 workshop diagram for BUJ

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Fit protective covers on bodywork .
2. Remove engine compartment trim panel (right-side) (3)53.
3. Extend spoiler with drive unit Owner's Manual.
4. Unscrew bolts (arrows) and remove cover (1) for tail light cluster.
5. R8 GT: Remove centre section for bumper cover 63.

6. Unplug electrical connector (1).
7. Remove nuts (arrows).
8. Remove rear right wheel housing liner 66.
9. Press release tabs and disconnect secondary air hoses (arrows).
10. Remove nut (1), detach secondary air pump motor V101 and move electrical wiring clear.
11. Install rear wheel housing liner 66.
12. Install cover for tail light cluster 66.
13. Install centre section for bumper cover 63.
14. Install engine compartment trim panel 53.

Other AUDI procedures

• Removing and installing air filter elements - vehicles with dual clutch gearbox 0BZ
• Removing and installing combination valve for secondary air system (left-side) - vehicles with manual gearbox/R tronic gearbox 086
• Removing and installing combination valve for secondary air system (left-side) - vehicles with dual clutch gearbox 0BZ
• Checking vacuum unit for exhaust flap
• Removing and installing air cleaner housing - R8 Coupé with manual gearbox/R tronic gearbox 086
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures