Removing and installing seat belt (3rd row): Audi Q7
Step-by-step removing and installing seat belt (3rd row) for the Audi Q7: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q7 (4L, 2005–2015)
Don't miss
- Make sure that seat belt is not impeded by wires, insulation or similar.
📋 Procedure
- Remove luggage compartment side trim .
- Remove D-pillar trim .
- When doing so, detach belt exit point trim from D-pillar trim to thread out belt.
- Detach guide fitting from body.
- Unscrew bolt securing belt reel.
- Take out belt reel.
- Engage hook (arrow A) of belt reel (1) in body recess (arrow B).
- Tighten securing bolt for belt reel to specified torque.
- Attach guide fitting to body. While doing so, insert spacer ring between guide fitting and body.
- Make sure that seat belt is not impeded by wires, insulation or similar.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing carrier unit
- Removing undamaged sliding window for sliding door
- Removing and installing clutch master cylinder with mounting bracket removed
- Removing and installing rear bonded rubber bush for rear final drive
- Removing and installing left side panel trim, »California Coast and Ocean«
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.