Removing and installing rear bonded rubber bush for rear final drive — AUDI

🧭 Before you start

Fits: platform codes SF, SG

Don't miss

• Mark installation location of bonded rubber bush for gearbox, e.g. using felt pen.
• Thrust piece T50008/4 must be pressed completely to cross member.

📋 Procedure

1. Remove rear final drive together with gearbox carrier .
2. Remove gearbox carrier from rear final drive .
3. Unscrew bolts (1) and remove cross member (2).
4. Mark installation location of bonded rubber bush for gearbox, e.g. using felt pen.
5. Press bonded rubber bush out of cross member as shown in figure.

6. Press bonded rubber bush into cross member as shown in figure.
7. Thrust piece T50008/4 must be pressed completely to cross member.
8. Install cross member.
9. Screw on cross member »finger-tight« using bolts (1) .
10. Then align the cross member centrally to the bolt holes. Tighten bolts (1).
11. Install gearbox carrier on rear final drive .
12. Install rear final drive together with gearbox carrier .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking intake manifold change-over function
• Checking function of ignition key removal lock – Audi A3
• Removing and installing stub shaft (right-side) – Audi A3
• Removing and installing pump for exhaust gas recirculation cooler V400
• Removing and installing exhaust gas temperature sender 2G448