Removing and installing left side panel trim, »California Coast and Ocean« — AUDI

🧭 Before you start

Fits: platform code SG

📋 Procedure

1. ⚠ To prevent damage/scratching of adjacent surfaces in interior, mask around components and their adjacent surfaces using commercially available adhesive tape and/or cover/mask using plastic foil. — Remove upper B-pillar trim .
2. Removing left C-pillar trim .
3. Removing roof storage compartment .
4. Removing and installing right cover for storage compartment .
5. Remove D-pillar trim .

6. Remove cupboard .
7. Switch off ignition and all electric loads and then remove ignition key.
8. Remove clamping pins for spreader rivets (2) on C-pillar using 3 mm hexagon key.
9. Then remove spreader rivet for right side panel trim (1).
10. Unscrew bolts (2) for left side panel trim (1).
11. Remove left side panel trim.
12. Renew bolts (2) for left side panel trim (1), and screw them in.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing cylinder head cover – Audi TT Mk1
• Removing and installing exhaust manifold – Audi TT Mk1
• Installing sump (top section) - engines with moulded gasket · 4 torque figures
• Removing and installing exhaust manifold (right-side) with intermediate pipe · 2 torque figures
• TDI injection and glow plug system (6-cyl.) — Fault table: fault codes 00513...00671